Skip to main content

FAQ

Q: Why does ping.py report an incorrect status packet when I connect two servos at the same time?

A: The servo factory default ID is 1. Multiple servos with the same ID are not allowed on the same bus. Otherwise, an ID conflict will occur, causing abnormal status packet returns. Please set different IDs for different servos according to the servo protocol and memory table addresses. Before modifying memory table parameters, unlock the EPROM area first; otherwise, the settings will not be saved after power-off.

Q: Can I use a mounting screw that presses against the servo housing?

A: No. If the screw is too long and presses against the servo body when tightened, it will increase the servo's operating resistance, causing the current to rise and, in severe cases, burning out the servo.

Q: What signal levels should I use for the servo data pin?

A: The signal high-level voltage is 2V-5V, and the low-level voltage is 0.0V-0.45V.

Q: Which connector should I use for the servo interface?

A: 5264-3P.

Q: Which screws are included with the ST3215 Servo?

A: Self-tapping screw: 3×5 mm; round-head self-tapping screw: 2×6 mm; round-head screw: M3×6 mm.