FAQ
Q: Does this screen support Arduino VENTUNO Q?
It is currently not supported for use with the Arduino VENTUNO Q. Please use it with the Arduino UNO Q.
Q: Why is there no display after connecting the screen?
-
Check whether a 5 V / 3 A power supply is connected through the UNO Q's USB-C port, and confirm that the board has booted normally.
-
Disconnect the power, and check whether the JMEDIA and JMISC connectors between the UNO Q and the expansion board are properly inserted and fully seated.
-
Enter the UNO Q terminal and run the following command to check the display configuration:
sudo arduino-linux-config carrier show media-carrierConfirm that the display configuration is
10-dsi-touch-a. If the configuration has not yet taken effect, save your current work and restart the device. -
If the display still does not work properly, record the system version, configuration output, and device startup behavior, and contact technical support.
Q: Does the Type-C port on the carrier board need a separate power supply?
Usually not. When running high-load tasks, if the screen has insufficient power, you can connect a 5 V power supply to the carrier board's Type-C port for auxiliary power.
This port cannot power the UNO Q board; the UNO Q still needs to be powered through its own power port.
Q: Why can't I find the arduino-linux-config command or the 10-dsi-touch-a display configuration?
This problem may be caused by an older version of the UNO Q system that does not yet include the required configuration tools or display presets.
- Confirm that the relevant commands are executed in the UNO Q's Linux terminal, not in your computer's local terminal.
- If it reports that the command does not exist, or the
10-dsi-touch-adisplay configuration cannot be found, please refer to Old System Check and Update to update the UNO Q system. - After the update is complete, run
sudo arduino-linux-config carrier listto view the available configurations again.
Q: Why does my screen have an image, but the touch position is wrong?
If the touch position does not match the actual tap position, or the touch direction is wrong after the screen is rotated, the display orientation and the touch coordinate mapping may not match.
Please refer to Screen Rotation to check the screen rotation direction and touch coordinate mapping configuration, ensuring that the touch direction matches the display direction.
Q: Why can't a single camera be recognized properly when only one is connected?
When both CAMERA0 and CAMERA1 are enabled, but only one camera is connected, please connect the camera to the CAMERA0 interface.
It is recommended to go to Settings > Carriers in Arduino App Lab, set CAMERA0 to type1-2lanes and CAMERA1 to none, then click Apply and Reboot, and wait for the device to restart before re-detecting the camera.
Q: Why can't recording work properly after connecting a microphone?
-
Check the interface connection: Confirm that the microphone is connected to the MIC-IN/HPH interface, not the Earphones Out interface. The latter only supports audio output and does not support microphone input.
-
Check the input device: Open Volume Control > Input Devices, confirm that the correct microphone input device is selected, and unmute it.
-
Check the recording gain: First confirm the actual sound card number and the allowed range of that control item. The following uses sound card 0 as an example; when the range includes 70, you can run:
amixer -c 0 cset name='TX_DEC0 Volume' 70